Electricity will travel through the cracks and possibly cause electrocution. If you see any damage, use a different multimeter. ... Use needle-nose pliers to hold the wires while you tighten the terminal screw. Hold the insulated part of the wire with the end of your pliers. Put the exposed end into the new terminal and use your other hand to ...

Unplug the touch lamp and remove the light bulb if it still doesn't work. Look inside the socket for a small brass tab. Use your fingers, needle-nose pliers or a small flat-head screwdriver to ...

A wire stripped and cutter, or needle nose pliers, to bend and shape the electrical wiring. An electrical outlet testing tool, to ensure the outlets are working properly, or do not have current running through them. ... Make sure to put the “reset” button to get electricity flowing through the outlet again. That’s it! If you have ...

Using electrician’s pliers, twist together the stripped ends of the corresponding wires from each strand of 12/2 Romex, white wire to white and black to black.

Pull the wire connectors off of the capacitor with needle-nose pliers. Lay a screwdriver across the capacitor's terminal. This discharges the capacitor. Turn a multimeter to the "Ohm" setting. Touch the multimeter's probes on the capacitor's terminals and watch the meter's reading.

We know, you turned the disposal off, but it’s still very possible to accidentally nick your finger. Instead, use a pair of tongs or needle-nose pliers to remove any objects trying to hitch a ride down the drain. To clean your disposal, dump a full tray of ice cubes and ½ cup of rock salt into the drain.

Bulb Removal Technique #1: Needle Nose Pliers. This method is simple, but proceed slowly and cautiously that you do not damage the light fixture.Grab a pair of needle nose pliers from your toolbox ...

Pliers (needle nose) Screwdriver; Knife; Wire stripper ** Warning! Do not start doing anything until you make sure that no power is going through the wires! Turn the power OFF by flipping the appropriate circuit breaker and double-check it with a non-contact voltage tester. ... Electricity source and light are connected to the same 3-way switch ...

Light switches simply serve to disrupt, or “break,” the flow of electricity in the wiring before it gets to the light fixture. This interruption in the flow is what turns the light off, and then back on. ... I usually do this by holding the bare wire between a pair of needle nose pliers and then rotating the wrist to make the hook shape in ...

These pliers are also known as long-nose, pinch-nose, pointy-nose, and snipe-nose pliers. They are both cutting pliers and holding pliers. They are instantly recognizable due to their long thin nose that tapers to a point. Needle-nose pliers are widely used by jewelers, artisans, electricians, and network engineers for delicate work in small areas.